Page 1OWNER’S MANUALAND INSTALLATION INSTRUCTIONSULTRASAVER 90 PLUSWALL FURNACEMODELSPVS18(N,P)-1PVS35(N,P)-1Attention: Check local codes for venting
32084-6-0214Page 10Wall Furnace Operations Sequence1. When the main power switch is turned on, the red and green control board LED’s will begin to a
32084-6-0214 Page 117. The blower will activate after 45 to 70 seconds depending on heat level. The blower will automatically adjust its speed to mat
32084-6-0214Page 12OWNER’S MANUALHumidier OperationWith the optional humidication tray kit (page 15), as the wall fur-nace operates condensate is co
32084-6-0214 Page 13INSTALLATION INSTRUCTIONSEMPIREEMPIREComfort Systemswww.empirezoneheat.com
32084-6-0214Page 14What tools are needed for installation?Pipe WrenchAdjustable WrenchDrillTape Measure10” x 5/16” Nut DriverThread SealantLevel2-1/2”
32084-6-0214 Page 15ImportantAll correspondence regarding repair and service should refer to complete Model Number, Serial Number and type of gas.ACCE
32084-6-0214Page 16SPECIFICATIONSModels PVS18(N,P) PVS35(N,P)Maximum Input BTU/HR (KW/H)* 17,500 (5.13) 35,000 (10.26)Minimum Input BTU/HR (KW/H)* 8,7
32084-6-0214 Page 17Select a location with adequate accessibility clearances for servicing and proper installation. Locate the wall furnace within 5 f
32084-6-0214Page 18INTRODUCTIONWALL FURNACE DISPLAYFigure 24
32084-6-0214 Page 19WALL FURNACE COMPONENT ARRANGEMENT - FRONTINTRODUCTIONFigure 25Figure 26
32084-6-0214Page 2TABLE OF CONTENTSIMPORTANT SAFETY INFORMATION ... 3SAFET
32084-6-0214Page 20WALL FURNACE COMPONENT ARRANGEMENT - REARINTRODUCTIONFigure 27Figure 28
32084-6-0214 Page 21Tools Needed Pipe Wrench Adjustable Wrench Drill Tape Measure 10” x 5/16” Nut Driver Thread Sealant Level 2-1/2” Diameter
32084-6-0214Page 22All gas piping must be installed in compliance with local codes and utility regulations. In the absence of local codes the installa
32084-6-0214 Page 23Gas Supply Line to Wall furnace1. Pull the factory installed exible gas line through the hole in the back panel. See Figure 34.2
32084-6-0214Page 24Figure 36US Installation 1A = Clearance above any grade, veranda, porch or balcony 12 in (30 cm)B = Clearance to window or door tha
32084-6-0214 Page 25 WARNINGThis appliance must not be vented with any other applianc-es, even if that appliance is of the condensing type. Com-mon ve
32084-6-0214Page 26VENTINGInstall Vent Termination and PipingThe UltraSaver may be installed with up to 50’ equivalent length venting.Notice: For ea
32084-6-0214 Page 27VENTINGDue to the high efciency of the Ultra Saver, condensate will form in the heat exchanger and ue pipe. A condensate trap an
32084-6-0214Page 28Table 3 - Equivalent Vent Length Example (See Figure 45)EVL = Equivalent Vent LengthEVL must be greater than or equal to 1’ and les
32084-6-0214 Page 29Determining Minimum Vent Height Above the RoofAll vent components are supplied by the installer.Determining Minimum Vent Height Ab
32084-6-0214 Page 3IMPORTANT SAFETY INFORMATIONTHIS IS A HEATING APPLIANCEWARNINGThis appliance must be installed and repaired by a quali-ed service
32084-6-0214Page 30The PVSA1 Air Pipe Kit is required for installation of the wall fur-nace in a direct-vent conguration. See Page 15.Max Vent Run -
32084-6-0214 Page 31Notice: The vent terminal elbow does not contribute to the overall vent length measurement. For each 45° elbow in
32084-6-0214Page 32A. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the oor because some gas is heavier than
32084-6-0214 Page 33This appliance is equipped with a three-prong grounding plug and should be plugged directly into a properly grounded three-prong r
32084-6-0214Page 34Optional ControlsWARNINGPotential risk of re, electric shock, and personal injury. Take precautions to reduce such risks.C
32084-6-0214 Page 35A. With main electrical power to the wall furnace turned off, verify that any external controls are in the off position or are ad
32084-6-0214Page 36INITIAL STARTUP AND ADJUSTMENTSWALL FURNACE INSTALLATIONThe table below outlines the BTU input rate of the wall furnace for each a
32084-6-0214 Page 37TROUBLESHOOTINGTROUBLESHOOTING LCD CODES - NORMAL OPERATIONOPERATION LCD DIGITS CONTROL BOARD LED SEQUENCEPower on sequence BlankY
32084-6-0214Page 38MAINTENANCE & SERVICERECOMMENDED MAINTENANCEMAINTENANCE ITEMFREQUENCY OF MAINTENANCEMONTHLY BY HOME-OWNERANNUALLY BY SERVICE PE
32084-6-0214 Page 39MAINTENANCE & SERVICEMaintenance for the Service PersonCirculating Air BlowerThe circulating air blower should be checked and
32084-6-0214Page 4SAFETY INFORMATION FOR USERS OF LP-GASPropane (LP-Gas) is a ammable gas which can cause res and explosions. In its natural state,
32084-6-0214Page 40PARTS LISTWARNINGUse only manufacturer’s replacement parts. Use of any other parts could cause injury or death.INDEX NO.PART NO.DES
32084-6-0214 Page 41EXPLODED VIEW
32084-6-0214Page 42To Order Parts Under Warranty, please contact your local Empire dealer. See the dealer locator at www.empirecomfort.com. To provide
32084-6-0214 Page 43WARRANTYEmpire Comfort Systems Inc. warranties this space heating product to be free from defects at the time of purchase and for
32084-6-0214Page 44EMPIREEMPIREComfort SystemsEmpire Comfort Systems Inc.918 Freeburg Ave. Belleville, IL 62220If you have a general question about ou
32084-6-0214 Page 5REQUIREMENTS FOR MASSACHUSETTSFor all side wall horizontally vented gas fueled equipment installed in every dwelling, building or s
32084-6-0214Page 6GENERAL SAFETY INFORMATION WARNINGThe safety information listed below must be followed during the installation, service, and
32084-6-0214 Page 7OWNER’S MANUAL AND OPERATION INSTRUCTIONSEMPIREEMPIREComfort Systemswww.empirezoneheat.com
32084-6-0214Page 8OWNER’S MANUALBefore You Start 1. Verify there is electrical power to the wall furnace. Verify the Main Power Switch is turned on.
32084-6-0214 Page 92. When the external control is activated, the wall furnace dis-play panel will illuminate and show the heat level along with the
Comments to this Manuals